Home › ENGINE ยท 2AZ-FE › STARTING › STARTER (for 1.7 kW Type)

STARTER (for 1.7 kW Type) > REASSEMBLY

for Preparation Click here


HINT:
Use high-temperature grease to lubricate the bearings, gears, return spring and steel ball when assembling the starter.



1. INSTALL PLANETARY GEAR


    A081656E01
  1. Apply grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears.



2. INSTALL STARTER ARMATURE ASSEMBLY


    A082440E01
  1. Apply grease to the plate washer and the armature shaft.

  1. Install the starter armature to the starter commutator end frame.

  1. Using snap ring pliers, install the plate washer and a new snap ring.



    A058810E01
  1. Using a vernier caliper, measure the length of the snap ring.

    Maximum length:
    5.0 mm (0.197 in.)

    If the length is greater than the maximum, replace it with a new snap ring.



3. INSTALL STARTER COMMUTATOR END FRAME COVER


    A081178
  1. Install the end frame cover to the commutator end frame.



4. INSTALL STARTER ARMATURE PLATE


    A073991E04
  1. Insert the armature plate to the starter yoke.

  1. Align the keyway of the starter plate with the key inside the starter yoke, and install the starter plate.



5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY


    A079727E01
  1. Align the rubber of the end frame with the cutout of the starter yoke.

  1. Install the end frame to the starter yoke.



6. INSTALL STARTER YOKE ASSEMBLY


    A079728E01
  1. Align the protrusion of the starter yoke with the cutout of the starter drive housing.



    A079720
  1. Install the starter yoke with the 2 through-bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }



7. INSTALL MAGNETIC SWITCH ASSEMBLY


    A079729
  1. Apply grease to the plunger and the hook.

  1. Hang the plunger hook of the magnetic switch to the drive lever.

  1. Install the plunger and return spring.



    A079719
  1. Install the magnetic switch with the 2 screws.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



    A079718
  1. Connect the lead wire to the magnetic switch with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }