Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    D003654E01
  1. Using SST and a hammer, tap in a new oil seal to the oil pump body.

    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flat with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with MP grease.



2. INSTALL FRONT OIL PUMP BODY O-RING


    C055817E03
  1. Coat a new O-ring with ATF, and install it to the oil pump body.

    NOTICE:
    1. Make sure that the O-ring is not twisted or pinched.
    2. Apply enough ATF to the O-ring before installation.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    C119012E05
  1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marks facing upward.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D009206E13
  1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marks facing upward.



5. INSTALL STATOR SHAFT ASSEMBLY


    D003651E01
  1. Set the stator shaft and align it with each bolt hole.

  1. Using a "TORX" socket wrench T30, install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



6. INSTALL CLUTCH DRUM OIL SEAL RING


    D026627E02
  1. Coat 2 new clutch drum oil seal rings with ATF.

  1. Install the 2 clutch drum oil seal rings.

    NOTICE:
    Do not expand the ring ends excessively.



7. INSPECT OIL PUMP ASSEMBLY


    D009205E01
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the lip of the oil seal.