Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › UNDERDRIVE CLUTCH

UNDERDRIVE CLUTCH > INSPECTION

for Preparation Click here



1. INSPECT UNDERDRIVE PACK CLEARANCE


    D026429E01
  1. Install the underdrive clutch to the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. Install a dial indicator as shown in the illustration.

  1. Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    1.51 to 1.71 mm (0.0594 to 0.0673 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.

    HINT:
    There are 5 different thicknesses of flanges available.

    Standard flange thickness:
    Mark
    Thickness
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    4
    3.6 mm (0.142 in.)
    2
    3.2 mm (0.126 in.)
    5
    3.8 mm (0.150 in.)
    3
    3.4 mm (0.134 in.)
    -
    -



2. INSPECT NO. 1 UNDERDRIVE CLUTCH DISC


    D004077E01
  1. Check if the sliding surfaces of the discs, plates and flange are worn or burnt. If necessary, replace them.

    NOTICE:
    1. If the lining of a disc comes off or is discolored, or if a part of the groove is worn, replace all the discs.
    2. Before installing new discs, immerse them in ATF for at least 15 minutes.



3. INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY


    D008129E02
  1. Using a caliper gauge, measure the inside diameter of the underdrive clutch drum bushing.

    Standard inside diameter:
    37.06 to 37.08 mm (1.4591 to 1.4598 in.)

    Maximum inside diameter:
    37.13 mm (1.4618 in.)

    If the inside diameter is greater than the maximum, replace the underdrive clutch drum sub-assembly.



4. INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY


    D003824E02
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    17.14 mm (0.6748 in.)