FRONT SEAT ASSEMBLY (for Manual Seat) > INSTALLATION |
| 1. INSTALL FRONT SEAT ASSEMBLY |
Place the seat in the cabin.
Connect the connector under the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Install the 2 bolts to the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the foremost position.
![]() |
Install the 2 bolts to the rear side of the seat.
| 2. INSPECT AND ADJUST SEAT SLIDE ADJUSTER LOCKS |
During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
If the seat adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster's position.
| 3. INSTALL FRONT SEAT TRACK BRACKET OUTER COVER LH |
![]() |
Install the outer cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
| 4. INSTALL FRONT SEAT TRACK BRACKET INNER COVER LH |
![]() |
Install the inner cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
| 5. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).
| 8. INSPECT FRONT SEAT ASSEMBLY |
w/ Seat Heater System:
Check the seat heater operation.
Turn the ignition switch on (IG).
Push the seat heater switch ON.
Wait 5 minutes or more and confirm that the seat surface becomes warm.