VEHICLE STABILITY CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK AND CLEAR DTC* |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
| Symptom does not occur. | A |
| Symptom occurs. | B |
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)* |
Using the intelligent tester, check for normal functioning of the CAN communication system.
Perform bus check (communication malfunction DTC).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| |||||
| 7.CHECK FOR DTC* |
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table. | A |
| Fault is listed in problem symptoms table. | B |
|
| ||||
| |||||
| 9.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here)
Data List/Active Test (Click here)
|
| ||||
|---|---|---|---|---|---|
| 10.CHECK FOR FLUID LEAKAGE |
| |||||
| 11.REPAIR OR REPLACE |
| |||||
| 12.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|