Home
›
ENGINE ยท 1AZ-FE
›
ENGINE CONTROL SYSTEM
›
SFI SYSTEM
DTC P1602 Deterioration of Battery
for Preparation
Click here
DESCRIPTION
The ECM determines the battery power according to the voltage of the BATT terminal while the engine is running (not cranking).
DTC No.
DTC Detection Condition
Trouble Area
P1602
Battery power is 0%
Battery
ECM back-up power source circuit
INSPECTION PROCEDURE
1.INSPECT BATTERY
Inspect battery specific gravity
Check the specific gravity of each cell.
Standard gravity:
1.25 to 1.29 at 20°C (68°F)
Inspect battery voltage
After the vehicle is driven for 20 minutes, stop the engine.
Turn the ignition switch on (IG), and turn on the headlights, blower fan and defogger for 1 minute.
Turn the ignition switch off.
Measure the battery voltage.
Standard voltage:
12.5 to 12.9 V at 20°C (68°F)
NG
REPLACE BATTERY
OK
CHECK ECU POWER SOURCE CIRCUIT