FRONT BRAKE > REASSEMBLY |
| 1. INSTALL FRONT DISC |
![]() |
Align the matchmarks and install the disc.
| 2. CHECK DISC RUNOUT |
![]() |
Check the axle hub bearing .
Tighten the disc with the 5 hub nuts.
Using a dial indicator, measure the disc runout 10.0 mm (0.39 in.) from the outer edge of the disc.
Remove the 5 hub nuts and disc.
| 3. TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG |
Temporarily install the bleeder plug to the cylinder.
Install the bleeder plug cap.
| 4. INSTALL PISTON SEAL |
![]() |
Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.
Install the piston seal to the cylinder.
| 5. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply lithium soap base glycol grease to the inner and outer circumference of a new cylinder boot, as well as the entire circumference of the top and bottom of the outer edge, as shown in the illustration.
Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the front disc brake piston where it contacts the cylinder boot and front disc brake cylinder.
Install the cylinder boot to the front disc brake piston.
| 6. INSTALL CYLINDER BOOT |
![]() |
Install the front disc brake piston to the front disc brake cylinder.
Install the cylinder boot to the cylinder.
Using a screwdriver, install a new set ring.
| 7. INSTALL FRONT DISC BRAKE BUSH DUST BOOT |
![]() |
Apply a light coat of lithium soap base glycol grease to the entire circumference of a new rear disc brake bush dust boot where it contacts the rear disc brake cylinder mounting, and the entire inner circumference of its both ends.
Install the 2 boots to the mounting.
| 8. INSTALL FRONT DISC BRAKE CYLINDER SLIDE BUSH |
![]() |
Apply a light coat of lithium soap base glycol grease to the front disc brake cylinder slide pin where it contacts front disc brake cylinder slide bush.
Install the front disc brake cylinder slide bush to the slide pin.
| 9. INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN |
![]() |
Apply lithium soap base glycol grease to the sliding part and the seal surface of the 2 front disc brake cylinder slide pins.
![]() |
Install the 2 slide pins (upper and lower) to the mounting.
| 10. INSTALL FRONT DISC BRAKE CYLINDER MOUNTING LH |
![]() |
Install the cylinder mounting with the 2 bolts.
| 11. INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE |
Install the 4 plates to the mounting.
| 12. INSTALL NO. 1 PAD WEAR INDICATOR PLATE |
Install the 2 indicator plates to the upper side of the pads.
| 13. INSTALL ANTI-SQUEAL SHIM KIT FRONT |
![]() |
w/ 10.83 inch Front Disc Brake:
Apply disc brake grease to both sides of each No. 1 shim.
Install the No. 1 and No. 2 shims to the pads.
![]() |
w/ 11.70 inch Front Disc Brake:
Install the No. 1 and No. 2 shims to the pads.
| 14. INSTALL FRONT DISC BRAKE PAD |
Install the 2 disc brake pads to the mounting.