CLUTCH SYSTEM (for 3ZR-FAE) > BLEEDING |
| 1. FILL BRAKE FLUID RESERVOIR |
| 2. BLEED CLUTCH LINE |
![]() |
| *1 | Bleeder Plug Cap |
| *2 | Bleeder Plug |
Remove the bleeder plug cap.
Connect a vinyl tube to the bleeder plug.
Depress the clutch pedal 5 times, and then loosen the bleeder plug while the pedal is depressed.
When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal.
Repeat both of the previous 2 steps 6 times.
Tighten the bleeder plug.
Depress the clutch pedal 10 times or more and confirm its operation.
Install the bleeder plug cap.
Check that all the air has been bled from the clutch line.
| 3. INSPECT BRAKE FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level and add fluid if necessary.