AIRBAG SYSTEM > Trouble in Passenger Airbag ON/OFF Indicator |

| 1.CHECK SRS WARNING LIGHT |
Turn the ignition switch on (IG), and check the SRS warning light condition.
|
| ||||
| OK | |
| 2.CHECK CONNECTOR |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor and the airbag cut-off switch.
|
| ||||
| OK | |
| 3.INSPECT AIRBAG CUT-OFF SWITCH |
![]() |
Disconnect the E68 passenger airbag manual cut-off switch connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (PMC-) - 2 (PMC+) | OFF | 80 to 120 Ω |
| 1 (PMC-) - 2 (PMC+) | ON | 320 to 480 Ω |
|
| ||||
| OK | |
| 4.CHECK INSTRUMENT PANEL WIRE (FOR OPEN) |
![]() |
Disconnect the instrument panel wire connector from the airbag cut-off switch.
Using a service wire, connect E68-1 (PMC-) and E68-2 (PMC+) of connector C.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E49-11 (MSW+) - E49-12 (MSW-) | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK INSTRUMENT PANEL WIRE (FOR SHORT) |
![]() |
Disconnect the service wire from connector C.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E49-11 (MSW+) - E49-12 (MSW-) | 1 MΩ or higher |
|
| ||||
| OK | |
| 6.CHECK INSTRUMENT PANEL WIRE (TO B+) |
![]() |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG).
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| E49-11 (MSW+)- Body ground | Below 1 V |
| E49-12 (MSW-) - Body ground | Below 1 V |
|
| ||||
| OK | |
| 7.CHECK INSTRUMENT PANEL WIRE (TO GROUND) |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E49-11 (MSW+) - Body ground | 1 MΩ or higher |
| E49-12 (MSW-) - Body ground | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||