POWER WINDOW CONTROL SYSTEM > TERMINALS OF ECU |
| CHECK POWER WINDOW REGULATOR MOTOR ASSEMBLY (ON DRIVER DOOR) (POWER WINDOW ECU) |

Disconnect the H4*1 or G9*2 motor connector (on the driver side).
Measure the resistance and voltage of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| GND (H4-1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| B (H4-2) - GND (H4-1) | GR - W-B | Battery power supply | Always | 9 to 14 V |
| UP (H4-10) - DOWN (H4-7) | P - W | Driver side door power window regulator motor UP DOWN | Always | Below 1 Ω |
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| GND (G9-1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| B (G9-2) - GND (G9-1) | GR - W-B | Battery power supply | Always | 9 to 14 V |
| UP (G9-10) - DOWN (G9-7) | W - B | Driver side door power window regulator motor UP DOWN | Always | Below 1 Ω |
Reconnect the H4*1 or G9*2 motor connector (on the driver side).
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| LED (H4-5) - GND (H4-1) | SB - W-B | Ignition power supply | Ignition switch on (IG) | 9 to 14 V |
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| LED (G9-5) - GND (G9-1) | LG - W-B | Ignition power supply | Ignition switch on (IG) | 9 to 14 V |
| CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |

Disconnect the H2*1 or G8*2 switch connector.
Measure the resistance and voltage of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E (H2-1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| B (H2-6) - Body ground | L - Body ground | Ignition power supply | Ignition switch on (IG) | 9 to 14 V |
| B (H2-6) - Body ground | L - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E (G8-9) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| B (G8-6) - Body ground | L - Body ground | Ignition power supply | Ignition switch on (IG) | 9 to 14 V |
| B (G8-6) - Body ground | L - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
Reconnect the H2*1 or G8*2 switch connector.
Reset the power window regulator motor.
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| U (H2-8) - E (H2-1) | P - W-B | Driver side door power window regulator motor UP output | Ignition switch on (IG), driver power window regulator switch off | 9 to 14 V |
| U (H2-8) - E (H2-1) | P - W-B | Driver side door power window regulator motor UP output | Ignition switch on (IG), driver side power window regulator switch UP (manual operation) | 9 to 14 V → Below 1 V |
| U (H2-8) - E (H2-1) | P - W-B | Driver side door power window regulator motor UP output | Ignition switch on (IG), driver side power window fully open → driver side power window regulator switch UP (AUTO operation) → driver side power window fully closed | Below 1 V → 9 to 14 V → Below 1 V |
| D (H2-5) - E (H2-1) | W - W-B | Driver side door power window regulator motor DOWN output | Ignition switch on (IG), driver side power window regulator switch DOWN (manual operation) | Below 1 V → 9 to 14 V |
| D (H2-5) - E (H2-1) | W - W-B | Driver side door power window regulator motor DOWN output | Ignition switch on (IG), driver side power window fully closed → driver side power window regulator switch DOWN (AUTO operation) → driver side power window fully open | Below 1 V → 9 to 14 V → Below 1 V |
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| U (G8-1) - E (G8-9) | W - W-B | Driver side door power window regulator motor UP output | Ignition switch on (IG), driver power window regulator switch off | 9 to 14 V |
| U (G8-1) - E (G8-9) | W - W-B | Driver side door power window regulator motor UP output | Ignition switch on (IG), driver side power window regulator switch UP (manual operation) | 9 to 14 V → Below 1 V |
| U (G8-1) - E (G8-9) | W - W-B | Driver side door power window regulator motor UP output | Ignition switch on (IG), driver side power window fully open → driver side power window regulator switch UP (AUTO operation) → driver side power window fully closed | Below 1 V → 9 to 14 V → Below 1 V |
| D (G8-5) - E (G8-9) | B - W-B | Driver side door power window regulator motor DOWN output | Ignition switch on (IG), driver side power window regulator switch off → DOWN (manual operation) | Below 1 V → 9 to 14 V |
| D (G8-5) - E (G8-9) | B - W-B | Driver side door power window regulator motor DOWN output | Ignition switch on (IG), driver side power window fully closed → driver side power window regulator switch DOWN (AUTO operation) → driver side power window fully open | Below 1 V → 9 to 14 V → Below 1 V |
| CHECK POWER WINDOW REGULATOR SWITCH (for Passenger Side) |

Disconnect the G3*1 or H8*2 switch connector.
Measure the voltage of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| B (G3-3) - Body ground | L - Body ground | Ignition power supply | Ignition switch on (IG) | 9 to 14 V |
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| B (H8-3) - Body ground | L - Body ground | Ignition power supply | Ignition switch on (IG) | 9 to 14 V |
Reconnect the G3*1 or H8*2 switch connector.
Measure the voltage of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| B (G3-3) - D (G3-1) | L - B | Passenger side door power window regulator motor UP output | Ignition switch on (IG), front passenger window regulator switch off | Below 1 V |
| B (G3-3) - D (G3-1) | L - B | Passenger side door power window regulator motor UP output | Ignition switch on (IG), front passenger window regulator switch UP | 9 to 14 V |
| B (G3-3) - U (G3-4) | L - Y | Passenger side door power window regulator motor DOWN output | Ignition switch on (IG), front passenger window regulator switch off | Below 1 V |
| B (G3-3) - U (G3-4) | L - Y | Passenger side door power window regulator motor DOWN output | Ignition switch on (IG), front passenger window regulator switch DOWN | 9 to 14 V |
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| B (H8-3) - D (H8-1) | L - W | Passenger side door power window regulator motor UP output | Ignition switch on (IG), front passenger window regulator switch off | Below 1 V |
| B (H8-3) - D (H8-1) | L - W | Passenger side door power window regulator motor UP output | Ignition switch on (IG), front passenger window regulator switch UP | 9 to 14 V |
| B (H8-3) - U (H8-4) | L - P | Passenger side door power window regulator motor DOWN output | Ignition switch on (IG), front passenger window regulator switch off | Below 1 V |
| B (H8-3) - U (H8-4) | L - P | Passenger side door power window regulator motor DOWN output | Ignition switch on (IG), front passenger window regulator switch DOWN | 9 to 14 V |
| CHECK POWER WINDOW REGULATOR SWITCH (for Rear Door Side) |

Disconnect the J1 or I1 switch connectors.
Measure the voltage of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| B (3) - Body ground | L - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
| B (3) - Body ground | L - Body ground | Ignition power supply | Ignition switch on (IG) | 10 to 14 V |
| U (4) - Body ground | R - Body ground | Power window motor UP output | Ignition switch on (IG), power window switch off → UP | Below 1 V → 10 to 14 V |
| D (1) - Body ground | G - Body ground | Power window motor DOWN output | Ignition switch on (IG), power window switch off → DOWN | Below 1 V → 10 to 14 V |
| SU (5) - Body ground | G - Body ground | Power window motor UP input (Remote) | Ignition switch on (IG), power window master switch off → UP (Remote) | Below 1 V → 10 to 14 V |
| SD (2) - Body ground | BR - Body ground | Power window motor DOWN input (Remote) | Ignition switch on (IG), power window master switch off → UP (Remote) | Below 1 V → 10 to 14 V |
| CHECK INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU) |

Disconnect the IA, IB and IE junction block connectors.
Disconnect the E18 ECU connector.
Measure the voltage and resistance of the wire harness side connectors.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| BECU (IB-30) - GND1 (IE-17) | R - W-B | Battery (power supply) | Always | 9 to 14 V |
| IG (IM-9) - GND1 (IE-17) | W - W-B | Ignition power supply | Ignition switch on (IG) | 9 to 14 V |
| IG (IM-9) - GND1 (IE-17) | W - W-B | Ignition power supply | Ignition switch off | Below 1 V |
| DCTY (IA-21) - Body ground*1 | W - Body ground | Driver side door courtesy light switch input | Driver side door closed | 10 kΩ or higher |
| DCTY (IA-21) - Body ground*1 | W - Body ground | Driver side door courtesy light switch input | Driver side door open | Below 1 Ω |
| PCTY (IC-14) - Body ground*1 | BR - Body ground | Front passenger side door courtesy light switch input | Front passenger side door closed | 10 kΩ or higher |
| PCTY (IC-14) - Body ground*1 | BR - Body ground | Front passenger side door courtesy light switch input | Front passenger side door open | Below 1 Ω |
| DCTY (IC-6) - Body ground*2 | BR - Body ground | Driver side door courtesy light switch input | Driver side door closed | 10 kΩ or higher |
| DCTY (IC-6) - Body ground*2 | BR - Body ground | Driver side door courtesy light switch input | Driver side door open | Below 1 Ω |
| PCTY (IA-24) - Body ground*2 | W - Body ground | Front passenger side door courtesy light switch input | Front passenger side door closed | 10 kΩ or higher |
| PCTY (IA-24) - Body ground*2 | W - Body ground | Front passenger side door courtesy light switch input | Front passenger side door open | Below 1 Ω |
| LIN2 (E18-23) - Body ground | V - Body ground | LIN communication | Always | 10 kΩ or higher |
| GND1 (IE-17) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |