Home › BODY ELECTRICAL › LIGHTING › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY (for Fender Type)


B131443
  1. Connect the connector and install the side turn signal light.

  1. Attach the side turn signal light with the 2 claws and install the light as shown in the illustration.



2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY (for Mirror Type)


    E173279
  1. Connect the connector.

  1. Install the 2 screws to install the light.



3. INSTALL OUTER MIRROR COVER LH (for Mirror Type)


    E173280
  1. Attach the 8 claws to install the mirror cover.

  1. Check that there is no gap between the cover and mirror body.

    HINT:
    If there is a gap between the cover and body, noise will occur during driving.



4. INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH (for Mirror Type)


    E173276
  1. w/ Mirror Heater:

    1. Connect the 2 connectors.



    E173277
  1. Attach the 4 claws to install the mirror.