Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT ASSEMBLY

ROOM LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE ROOM LIGHT LENS


B131447
  1. Using a screwdriver, detach the 4 claws and remove the lens.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE ROOM LIGHT ASSEMBLY


    B131448
  1. Using a screwdriver, detach the 4 claws and remove the 2 covers.

    HINT:
    Tape the screwdriver tip before use.



    B131449E01
  1. Remove the bulb from the room light switch base.



    B132733
  1. Using a screwdriver, detach the 4 claws and remove the light.

    HINT:
    Tape the screwdriver tip before use.



    B131451
  1. Using a screwdriver, detach the 4 claws and remove the room light switch base.

    HINT:
    Tape the screwdriver tip before use.