Home › BODY ELECTRICAL › LIGHTING › FRONT DOOR COURTESY SWITCH

FRONT DOOR COURTESY SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


B131444
  1. Remove the bolt and switch.

  1. Disconnect the connector.