Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER RUBBER

FRONT WIPER RUBBER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL WIPER RUBBER


    I030020E01
  1. Install the 2 packing plates to the rubber.

    NOTICE:
    Install the packing plates facing the proper direction.



    B131950
  1. Install the wiper rubber to the claw of the wiper blade in the direction indicated by the arrow in the illustration.

    HINT:
    Install the wiper rubber so that the head part (large side) of the wiper rubber faces the arm axle side.



    B108990E02
  1. Attach the head part (large side) of the wiper rubber to the rear end side claw of the wiper blade.

    NOTICE:
    Push the wiper blade into the grooves of the wiper rubber to attach them completely.



2. INSTALL WIPER RUBBER (for Plastic Type)


E125260
  1. Install the 2 packing plates to the rubber.

    NOTICE:
    Install the packing plates facing the proper direction.



    E125261
  1. Install the wiper rubber to the claw of the wiper blade in the direction indicated by the arrow in the illustration.

    HINT:
    Install the wiper rubber so that the head part (large side) of the wiper rubber faces the arm axle side.

  1. Attach the head part (large side) of the wiper rubber to the rear end side claw of the wiper blade.

    NOTICE:
    Push the wiper blade into the grooves of the wiper rubber to attach them completely.



3. INSTALL FRONT WIPER BLADE


    B113198
  1. Attach the claw to install the wiper blade.



4. INSTALL FRONT WIPER BLADE (for Plastic Type)



B136372E01

  1. Install the wiper blade.

  1. Install the holder as shown in the illustration.