Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER RUBBER

FRONT WIPER RUBBER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WIPER BLADE


    B113197
  1. Detach the claw as shown in the illustration.



    B113199
  1. Remove the wiper blade as shown in the illustration.

    NOTICE:
    Do not fold the wiper arm with the wiper blade removed. The arm tip may damage the windshield surface.



2. REMOVE FRONT WIPER BLADE LH (for Plastic Type)



B136371E01

  1. Remove the wiper blade holder as shown in the illustration.

  1. Remove the wiper blade.



3. REMOVE WIPER RUBBER


    E057398
  1. Detach the head part (large side) of the wiper rubber from the wiper blade.



    B108991E02
  1. Remove the wiper rubber in the direction indicated by the arrow in the illustration.

    NOTICE:
    Do not pull out the wiper rubber forcibly. Doing so will deform the backing plate or damage the blade claw.

  1. Remove the 2 wiper rubber backing plates from the wiper rubber.



4. REMOVE WIPER RUBBER (for Plastic Type)


E125259
  1. Detach the head part (large side) of the wiper rubber from the wiper blade.

  1. Remove the wiper rubber in the direction indicated by the arrow in the illustration.



    E125260
  1. Remove the 2 wiper rubber backing plates from the wiper rubber.