NAVIGATION SYSTEM (for DVD) > DTC CHECK / CLEAR |
| START DIAGNOSTIC MODE |
There are 2 methods to start diagnostic mode. Start the mode by using one of them.
![]() |
Method 1
Start the engine.
While pressing and holding the "INFO" switch, operate the light control switch: Off → Turn On → Turn Off → Turn On → Turn Off → Turn On → Turn Off.
The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.
Method 2
Start the engine.
![]() |
Press the "DISPLAY" switch.
![]() |
From the display quality adjustment screen, touch the corners of the screen in the following order: upper left → lower left → upper left → lower left → upper left → lower left.
The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.
| FINISH DIAGNOSTIC MODE |
There are 2 methods to end diagnostic mode. Use one of them.
Turn the ignition switch off.
Press and hold the "DISP" switch for 3 seconds.
| DIAGNOSIS MENU |
![]() |
Press the "MENU" switch on the "System Check Mode" screen.
![]() |
The "Diagnosis MENU" screen will be displayed.
| CHECK DTC |
Read the system check result.
![]() |
If the check result is "EXCH", "CHEK" or "Old", touch the displayed check result.
![]() |
View the results on the "Unit Check Mode" screen and record them.
![]() |
When proceeding to view the results of another device, press the "Service" switch to return to the "System Check Mode" screen.
Read the communication diagnostic check result.
![]() |
Return to the "System Check Mode" screen, and press the "LAN Mon" switch.
![]() |
The "LAN Monitor" screen is displayed.
![]() |
If the check result is "CHEK" or "Old", touch the displayed check result.
![]() |
View the results on the individual communication diagnostic screen and record them.
![]() |
| DTC CLEAR/RECHECK |
![]() |
Clear DTC
Press the "Code CLR" switch for 3 seconds.
The check results are cleared.
![]() |
Recheck
Press the "Recheck" switch.
![]() |
Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, troubleshoot again.
![]() |
Press the "LAN Mon" switch to change to the "LAN Monitor" screen.
![]() |
Confirm that all diagnostic codes are "No Err". If a code other than "No Err" is displayed, troubleshoot again.