NAVIGATION SYSTEM (for HDD) > DTC CHECK / CLEAR |
| START DIAGNOSTIC MODE |
There are 2 methods to start diagnostic mode. Start the mode by using one of them.
Method 1
Start the engine.
![]() |
Press the "DISPLAY" switch.
![]() |
From the display quality adjustment screen, touch the corners of the screen in the following order: upper left → lower left → upper left → lower left → upper left → lower left.
The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.
Method 2
Start the engine.
![]() |
While pressing and holding the "INFO" switch, operate the light control switch: Off → Turn On → Turn Off → Turn On → Turn Off → Turn On →Turn Off.
The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.
| FINISH DIAGNOSTIC MODE |
Turn the ignition switch off.
| FAILURE DIAGNOSIS |
![]() |
Press the "Failure Diagnosis" switch on the "Service Menu" screen.
![]() |
The "Failure Diagnosis" screen will be displayed.
| SYSTEM CHECK MODE |
![]() |
Press the "System Check" switch on the "Failure Diagnosis" screen.
![]() |
The "System Check Mode" screen will be displayed.
| CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN) |
Read the system check result.
![]() |
If the check result is "EXCH" or "CHEK", touch the displayed check result.
![]() |
View the results on the "Unit Check Mode" screen and record them.
![]() |
When proceeding to view the results of another device, press the "Back" switch to return to the "System Check Mode" screen.
| DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN) |
![]() |
Clear DTC
Press the "Memory CLR" switch for 3 seconds.
The check results are cleared.
![]() |
Recheck
Press the "Recheck" switch.
![]() |
Confirm that all check results are "OK" when the check results are displayed. If a result other than "OK" is displayed, troubleshoot again.