FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Short Body) |
![]() |
Using a screwdriver, detach the 10 claws and remove the scuff plate.
| 3. REMOVE FRONT DOOR SCUFF PLATE LH (for Long Body) |
![]() |
Using a screwdriver, detach the 10 claws and remove the scuff plate.
| 4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| 5. REMOVE REAR DOOR SCUFF PLATE LH (for Short Body) |
![]() |
Using a screwdriver, detach the 8 claws and remove the scuff plate.
| 6. REMOVE REAR DOOR SCUFF PLATE LH (for Long Body) |
![]() |
Using a screwdriver, detach the 9 claws.
Using a clip remover, detach the 2 clips and remove the garnish.
| 7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
| 8. REMOVE CENTER PILLAR GARNISH LOWER LH |
![]() |
Remove the lap belt outer anchor cover.
Remove the anchor's built-in bolt from the pillar and disconnect the outer belt.
![]() |
Using a screwdriver, detach the 2 claws.
Using a clip remover, detach the 2 clips and remove the garnish.
| 9. REMOVE CENTER PILLAR GARNISH LH |
![]() |
Using a screwdriver, remove the 2 screws.
Using a clip remover, detach the clip, then remove the garnish.
Pull out the outer belt anchor from the center pillar garnish.
| 10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH |
![]() |
Remove the nut and disconnect the shoulder anchor.
![]() |
Disconnect the pretensioner connector as shown in the illustration.
![]() |
Remove the bolt and outer belt.
| 11. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH |
![]() |
Using a screwdriver, detach the 6 claws.
Remove the anchor plate from the garnish.
| 12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Remove the 2 bolts and anchor.