DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 | Case 1
|
|

| Item | Content |
| Terminals | CH1: G2+ - G2- CH2: NE+ - NE- |
| Equipment Settings | 5 V/DIV. 20 msec./DIV. |
| Conditions | Cranking or idling |
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the B6 Camshaft Position (CMP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Cold | 835 to 1400 Ω |
| 1 - 2 | Hot | 1060 to 1645 Ω |
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the B6 CMP sensor connector.
Disconnect the B32 ECM connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| G2+ (B6-1) - G2+ (B32-99) | Below 1 Ω |
| G2- (B6-2) - G2- (B32-98) |
| Tester Connection | Specified Condition |
| G2+ (B6-1) or G2+ (B32-99) - Body ground | 10 kΩor higher |
| G2- (B6-2) or G2- (B32-98) - Body ground |
Reconnect the ECM connector.
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR) |
![]() |
Check the CMP sensor installation.
|
| ||||
| OK | |
| 4.CHECK VALVE TIMING |
![]() |
Remove the cylinder head cover.
Turn the crankshaft pulley, and align its groove with the timing mark "0" on the timing chain cover.
Check that the timing marks on the camshaft timing sprocket and camshaft timing gear are facing upward as shown in the illustration.
Reinstall the cylinder head cover.
|
| ||||
| OK | |
| 5.CHECK CAMSHAFT |
Check the teeth of the camshaft.
|
| ||||
| OK | |
| 6.REPLACE CAMSHAFT POSITION SENSOR |
| NEXT | |
| 7.CHECK AND REPLACE WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear DTCs (Click here).
Start the engine.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Display (DTC Output) | Proceed to |
| No output | A |
| P0340 | B |
|
| ||||
| A | ||
| ||