Home › ENGINE · 3ZR-FAE › ENGINE CONTROL SYSTEM › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      6.9 to 7.9 Ω

      If the result is not as specified, replace the oil control valve assembly.



    A160184E04
  1. Check the operation.

    1. Connect the battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.

      OK:
      Condition
      Specified Condition
      Battery positive (+) voltage is applied
      Valve moves in left arrow direction shown in illustration
      Battery positive (+) voltage is cut off
      Valve moves in right arrow direction shown in illustration

      Text in Illustration 
      *1
      Component without harness connected
      (Camshaft Timing Oil Control Valve Assembly)

      NOTICE:
      Confirm that the valve moves freely and does not stick in any position.

      If the result is not as specified, replace the oil control valve assembly.

      HINT:
      Accumulation of foreign objects causes subtle pressure leaks. The subtle pressure leaks will cause the camshaft to advance, and this will cause a DTC to be set.