HOOD > ADJUSTMENT |

| 1. ADJUST HOOD SUB-ASSEMBLY |
![]() |
Adjust the hood's position.
Loosen the hood's 4 hinge bolts.
![]() |
Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.
| Area | Specified Condition |
| E | 3.5 +- 1.5 mm (0.138 +- 0.059 in.) |
| G | 3.5 +- 1.5 mm (0.138 +- 0.059 in.) |
| I | 3.5 +- 1.5 mm (0.138 +- 0.059 in.) |
Tighten the hood's 4 hinge bolts after the adjustment.
![]() |
Adjust the cushion rubber so that the height of the hood and fender are aligned.
![]() |
Raise or lower the hood's front end by turning the cushion rubber. Make sure that the clearance is within the standard range.
| Area | Specified Condition |
| F | 0.6 +- 1.5 mm (0.024 +- 0.059 in.) |
| H | 0.5 +- 1.5 mm (0.020 +- 0.059 in.) |
| J | 0.0 +- 1.5 mm (0.000 +- 0.059 in.) |
![]() |
Adjust the hood lock.
Loosen the 3 bolts.
![]() |
Adjust the hood lock position so that the striker can enter it smoothly.
Tighten the 3 bolts after the adjustment.