Home › BODY › ENGINE HOOD / DOOR › HOOD (w/ Hood Moulding)

HOOD (w/ Hood Moulding) > ADJUSTMENT

for Preparation Click here


B057104E06

HINT:
  1. Centering bolts are used to mount the hood hinges and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. ADJUST HOOD SUB-ASSEMBLY


    B255913E01
  1. Adjust the hood position.

    1. Loosen the 4 hinge bolts on the hood.



    2. B255288E01
    3. Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.

      Standard measurement:
      Area
      Specified Condition
      E
      2.0 to 5.0 mm (0.0787 to 0.197 in.)
      G
      2.0 to 5.0 mm (0.0787 to 0.197 in.)
      I
      2.0 to 5.0 mm (0.0787 to 0.197 in.)

    4. Tighten the 4 hinge bolts on the hood.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    B252935
  1. Adjust the cushion rubber so that the heights of the hood and fender are aligned.



      B255289E01
    1. Raise or lower the front end of the hood by turning the cushion rubber. Make sure that the clearance is within the standard range.

      Standard measurement:
      Area
      Specified Condition
      F
      -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
      H
      -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
      J
      -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)



    B127328
  1. Adjust the hood lock.

    1. Loosen the 3 bolts.



    2. B127329
    3. Adjust the hood lock position so that the striker can enter it smoothly.

    4. Tighten the 3 bolts after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }