Home › BODY › ENGINE HOOD / DOOR › HOOD (w/ Hood Moulding)

HOOD (w/ Hood Moulding) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HOOD SUB-ASSEMBLY


  1. Check that the clearance measurements of areas A through K are within the standard range.


    B252927E01


    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    6.15 to 10.15 mm (0.242 to 0.399 in.)
    B
    6.15 to 10.15 mm (0.242 to 0.399 in.)
    C
    -0.2 to 3.8 mm (-0.0079 to 0.15 in.)
    D
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    E
    -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
    F
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    G
    -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
    H
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    I
    -1.0 to 2.0 mm (-0.0394 to 0.0787 in.)
    J
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    K
    -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
    -
    -