HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) > INSTALLATION |
| 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY |
Install the cable to the clamps, wire harness protector and wire harness grommet as shown in the illustration.

| 2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Connect the cable to the lever.
Attach the 3 claws to install the lever.
| 3. INSTALL HOOD LOCK ASSEMBLY |
![]() |
Connect the cable to the lock.
Install the lock with the 3 bolts.
Adjust the lock.
w/ Hood courtesy switch:
Connect the connector.
| 4. INSTALL RADIATOR SUPPORT OPENING COVER |
![]() |
Install the radiator support opening cover with the 9 clips.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |