Home › TRANSMISSION ยท CLUTCH › CLUTCH ACCUMULATOR (for 2AZ-FE)

CLUTCH ACCUMULATOR (for 2AZ-FE) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY


C127462
  1. Install the clutch accumulator with the bolt and 2 nuts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



    C125503
  1. Using a union nut wrench, connect the 2 flexible tubes.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where union nut wrench is combined with a torque wrench (Click here).



2. BLEED AIR FROM CLUTCH PIPE LINE
  1. Fill the master cylinder reservoir with fluid.

  1. Bleed air from the clutch system.



3. INSPECT FLUID LEVEL


C126431
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1703 or FMVSS No. 116 DOT3

    HINT:
    Add fluid to a level between the reservoir's MIN and MAX lines.



4. INSPECT FOR FLUID LEAK
  1. Check for leaks in the clutch system.