INTEGRATION RELAY > ON-VEHICLE INSPECTION |
| 1. REMOVE ENGINE ROOM NO. 1 RELAY BLOCK COVER |
| 2. INSPECT INTEGRATION NO.1 RELAY (UNIT A: HORN RELAY) |
![]() |
Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.
![]() |
Measure the resistance of the integration relay.
| Tester Connection | Specified Condition |
| 1A-8 - 1C-1 | 10 kΩ or higher |
| 1A-8 - 1A-5 | |
| 1A-8 - 1C-1 | Below 1 Ω (when battery voltage is applied to terminals 1A-7 and 1A-6) |
| 1A-8 - 1A-5 |
| 3. INSTALL ENGINE ROOM NO. 1 RELAY BLOCK COVER |