IGNITION KEY CYLINDER LIGHT > INSTALLATION |
| 1. INSTALL TRANSPONDER KEY AMPLIFIER |
![]() |
Attach the 2 claws and install the transponder key amplifier to the steering column upper with the switch bracket.
| 2. INSTALL STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
![]() |
Attach the 4 claws to install the lower steering column cover.
| 3. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks and install the steering wheel to the steering column.
Install the nut.
Connect all the connectors to the spiral cable.
| 4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 5. INSPECT STEERING WHEEL CENTER POINT |
| 6. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Attach the 2 spring to steering pad.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. INSPECT STEERING PAD ASSEMBLY |
Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
Check that the horn sounds.
| 9. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).