Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY


    B135621
  1. Attach the claw to install the headlight dimmer switch with the claw as shown in the illustration.



    B135620
  1. Install the headlight dimmer switch with the clamp.



    B088653
  1. Connect the connector.



2. INSTALL WIPER AND WASHER SWITCH ASSEMBLY


B133131
  1. Attach the claw to install the wiper switch.

  1. Connect the connectors.

    NOTICE:
    Do not push the claw with excessive force as damage may occur.



3. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.



    B127903E01
    B127902E01
  1. Install the spiral cable.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

  1. Connect the connectors to the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



    B127901E01
  1. Attach the 4 clips to the column cover (upper).



    B127900E02
  1. Install the steering column cover (upper).



4. INSTALL STEERING COLUMN COVER


    C204429
  1. Attach the claw to install the upper steering column cover.



    C204428
  1. Attach the 4 claws to install the lower steering column cover.



5. INSTALL STEERING WHEEL ASSEMBLY


    C195903E01
  1. Align the matchmarks and install the steering wheel to the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.



6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


7. INSPECT STEERING WHEEL CENTER POINT


8. INSTALL STEERING PAD ASSEMBLY


B220979
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. Attach the 2 spring to steering pad.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. INSPECT STEERING PAD ASSEMBLY
  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.



11. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).