INTEGRATION RELAY > ON-VEHICLE INSPECTION |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. INSPECT INTEGRATION RELAY |
![]() |
Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room No. 1 junction block.
Disconnect the 3 connectors from the integration relay.
Inspect the EFI MAIN relay.
![]() |
Check the resistance of the EFI MAIN fuse.
If the result is not as specified, replace the EFI MAIN fuse.
Measure the resistance of the integration relay.
| Tester Connection | Specified Condition |
| 1C-1 - 1A-4 | 10 kΩ or higher |
| 1C-1 - 1A-4 | Below 1 Ω (when battery voltage is applied to terminals 1A-2 and 1A-3) |
Inspect the A/F relay.
![]() |
Check the resistance of the A/F fuse.
If the result is not as specified, replace the A/F fuse.
Measure the resistance of the integration relay.
| Tester Connection | Specified Condition |
| 1C-1 - 1B-8 | 10 kΩ or higher |
| 1C-1 - 1B-8 | Below 1 Ω (when battery voltage is applied to terminals 1B-6 and 1B-7) |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |