Home › ENGINE · 3ZR-FAE › ENGINE CONTROL SYSTEM › INTEGRATION RELAY

INTEGRATION RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. INSPECT INTEGRATION RELAY (EFI MAIN)

NOTICE:
  1. The EFI relay is built into the integration relay (unit A: EFI MAIN).
  2. Some relays are built into the integration relay. The integration relay cannot be disassembled. If there is a malfunction in the circuit of the integration relay, replace the integration relay.



    A124574
  1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the No. 1 engine room junction block.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the 3 connectors from the integration relay.



    A107921E22
  1. Measure the resistance of the EFI MAIN fuse.

    1. Remove the EFI MAIN fuse from the integration relay.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      EFI MAIN fuse
      Always
      Below 1 Ω

      If the result is not as specified, replace the EFI MAIN fuse.

    3. Install the EFI MAIN fuse to the integration relay.

  1. Measure the resistance of the EFI MAIN relay.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1A-4 - 1C-1
      Battery voltage not applied to terminals 1A-3 and 1A-2
      10 kΩ or higher
      1A-4 - 1A-1
      1A-4 - 1C-1
      Battery voltage applied to terminals 1A-3 and 1A-2
      Below 1 Ω
      1A-4 - 1A-1

      If the result is not as specified, replace the integration relay.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL