Home › BRAKE › BRAKE › VACUUM PUMP (for 3ZR-FAE)

VACUUM PUMP (for 3ZR-FAE) > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A209051
  1. Disconnect the mass air flow meter connector.

  1. Detach the clamp.



    A209053
  1. Disconnect the No. 2 ventilation hose from the cylinder head cover.

  1. Squeeze the taps of the air cleaner hose clamp, and then disconnect the air cleaner hose from the throttle body.



    A209052
  1. Detach the 2 hook clamps, and then remove the air cleaner cap and hose.



3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A209057
  1. Disconnect the wire harness clamp from the air cleaner case.

  1. Remove the 3 bolts and air cleaner case.



4. DISCONNECT ENGINE WIRE
  1. Detach the 9 clamps, and then disconnect the connectors.



  1. Remove the 3 bolts and 2 nuts, and then disconnect the engine wire.


    A209046



5. DISCONNECT UNION TO CONNECTOR TUBE HOSE


C197844
  1. Slide the clip and disconnect the hose.



6. REMOVE VACUUM PUMP ASSEMBLY


    C197845
  1. Remove the 3 bolts and vacuum pump from the engine.



    C197846
  1. Remove the 2 O-rings from the vacuum pump.