Home › BODY › EXTERIOR › FRONT BUMPER (w/o Under Guard)

FRONT BUMPER (w/o Under Guard) > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



2. REMOVE CENTER HOOD CUSHION


    B209173
  1. Using a clip remover, remove the center hood cushion.



3. REMOVE RADIATOR GRILLE PROTECTOR


B209174
  1. Remove the 2 radiator grille protectors.



4. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH


B208332
  1. Remove the screw, bolt, nut and splash shield.



5. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

HINT:
Use the same procedure described for the LH side.



6. REMOVE FRONT BUMPER COVER


B208302
  1. Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH and LH sides.

  1. Remove the retainer.

    HINT:
    Use the same procedure for the RH and LH sides.



    B209171E01
  1. Put protective tape around the bumper cover.

  1. Using a clip remover, remove the 4 clips.

  1. Remove the 8 screws.



    B208306
  1. Detach the 4 claws and remove the bumper cover.

    HINT:
    The illustration only shows the LH side of the vehicle. The remaining claws are on the RH side.

  1. w/ Fog Light:
    Disconnect the 2 fog light connectors.



7. REMOVE FRONT NO. 2 BUMPER ENERGY ABSORBER


  1. Remove the energy absorber.


    B209931E01



8. REMOVE FRONT BUMPER ENERGY ABSORBER (w/ Front Bumper Lower Absorber)


B208311
  1. Remove the 2 energy absorbers.



9. REMOVE FRONT BUMPER LOWER ABSORBER (w/ Front Bumper Lower Absorber)


B208312
  1. Remove the lower absorber.



10. REMOVE FRONT BUMPER CENTER STAY SUB-ASSEMBLY


  1. Remove the 2 bolts and stay.


    B209927E01



11. REMOVE LOW PITCHED HORN ASSEMBLY


E173377
  1. Disconnect the horn connector.

  1. Remove the bolt and horn.



12. REMOVE HIGH PITCHED HORN ASSEMBLY


E173376
  1. Disconnect the horn connector.

  1. Remove the bolt and horn.



13. REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY


B211609
  1. Remove the 2 bolts and reinforcement.



14. REMOVE FRONT BUMPER REINFORCEMENT
  1. Detach the 3 clamps and remove the wire harness.



  1. Remove the 8 bolts and reinforcement.


    B209928E01



15. REMOVE FRONT BUMPER SIDE RETAINER LH


B209172
  1. Remove the bolt.

  1. Using a clip remover, detach the clip and remove the retainer.

    HINT:
    Tape the clip remover tip before use.



16. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure described for the LH side.