BACK DOOR OUTSIDE GARNISH (w/ Tire Carrier) > REMOVAL |
| 1. REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH |
Put protective tape around the back door outside garnish.
Remove the screw.
Remove the back door outside garnish.
Using a moulding remover, detach the clips and remove the back door outside garnish.

w/ License Plate Light:
Disconnect the license plate light connector.
w/ Rear Fog Light:
Disconnect the rear fog light connector.
Remove the clips from the back door panel.
Using a clip remover, remove the clip labeled A.
Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.

| 2. REMOVE BACK DOOR GARNISH COVER (for 1-piece Type) |
![]() |
Detach the 2 claws and remove the back door garnish cover.
| 3. REMOVE LICENSE PLATE LIGHT ASSEMBLY (w/ License Plate Light) |
Disconnect the connector.
![]() |
Using a screwdriver, remove the light as shown in the illustration.
| 4. REMOVE REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light) |
![]() |
Remove the 2 screws and rear fog light.
Disconnect the connector.
| 5. REMOVE UPPER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH |
![]() |
Remove the screw.
Using a moulding remover, detach the 6 clips and remove the back door outside garnish.
![]() |
Using a clip remover, remove the 2 clips labeled A.
Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.
| 6. REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY RH |
![]() |
Detach the 5 clips and claw, and remove the back door outside garnish.
![]() |
Using a clip remover, remove the clip labeled A.
Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.
| 7. REMOVE UPPER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY RH |
![]() |
Detach the 6 clips and remove the back door outside garnish.
![]() |
Using a clip remover, remove the 2 clips labeled A.
Turn the remaining clips 90° as shown in the part of the illustration labeled B, and remove them.