Home › TRANSMISSION ยท E352 MANUAL TRANSAXLE › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY


C127079
  1. Install the shift lever with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    C127220
  1. Install the wire harness with the 4 wire harness clamps.



2. CONNECT TRANSAXLE CONTROL CABLE ASSEMBLY


D026974E03
  1. Connect the ends of the control cable and install the 2 clips to the shift lever.



    D033172E03
  1. Turn the lock nuts of the shift cable 270° counterclockwise, and hold them in that position.

  1. Install the shift cable and select cable while holding the lock nuts.

  1. Check that the cables are installed securely.



    G032966E01
  1. Push in the cable locks of the shift cable and select cable.



3. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
  1. Connect the connector.



    B208604
  1. Install the rear console box with the 2 bolts and attach the wire harness clamp.



    B208603
  1. Install the 2 screws.



4. INSTALL CONSOLE REAR END PANEL


    B129879
  1. Attach the 6 claws to install the console rear end panel.



5. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B208374
  1. Connect the connectors.

  1. Attach the 4 clips to install the upper rear console panel.



6. INSTALL CONSOLE CUP HOLDER BOX


    B129881
  1. Attach the 2 clips to install the cup holder box.

  1. Install the 2 screws.



7. INSTALL SWITCH BASE


    B129882
  1. Connect the connectors.

  1. Attach the 2 clips and 2 claws to install the switch base.



8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B216882
  1. Attach the 2 clips and 4 claws to install the upper console panel.



9. INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH


    B208640
  1. Attach the 4 clips to install the upper panel garnish.



10. INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH


    B208641
  1. Attach the 4 clips to install the upper panel garnish.



11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B216884
  1. for Manual Transaxle:
    Twist the shift lever knob in the direction indicated by the arrow to install it.



    B208596
  1. for Automatic Transaxle:
    Twist the shift lever knob in the direction indicated by the arrow to install it.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL