Home › TRANSMISSION ยท E352 MANUAL TRANSAXLE › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH


    B208598E01
  1. Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 4 clips and remove the upper panel garnish.



3. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH


    B208599E01
  1. Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 4 clips and remove the upper panel garnish.



4. REMOVE SHIFT LEVER KNOB


    B216883
  1. for Manual Transaxle:
    Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B208597
  1. for Automatic Transaxle:
    Twist the shift lever knob in the direction indicated by the arrow and remove it.



5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B216882
  1. Using a screwdriver, detach the 2 clips and 4 claws, and then remove the upper console panel.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE SWITCH BASE


    B209104
  1. Detach the 2 clips and 2 claws.

  1. Disconnect the connectors and remove the switch base.



7. REMOVE CONSOLE CUP HOLDER BOX


    B129881
  1. Remove the 2 screws.

  1. Detach the 2 clips and remove the cup holder box.



8. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY


    B208374
  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors and remove the upper rear console panel.



9. REMOVE CONSOLE REAR END PANEL


    B129879
  1. Using a screwdriver, detach the 6 claws and remove the console rear end panel.

    HINT:
    Tape the screwdriver tip before use.



10. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY


    B208604
  1. Remove the 2 bolts and detach the wire harness clamp.



    B208603
  1. Remove the 2 screws.

  1. Disconnect the connector and remove the rear console box.



11. DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY


D026974E02
  1. Remove the 2 clips, and disconnect the cable ends of the control cable.



    D033170E04
  1. Using a screwdriver, release the cable locks of the shift cable and select cable.



    D033171E03
  1. Turn the lock nuts 180° counterclockwise and hold them in that position. Remove the shift cable and select cable while holding them.

    NOTICE:
    Do not push in the cable locks.



12. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY


C127220
  1. Detach the 4 clamps and disconnect the wire harness.



    C127079
  1. Remove the 4 bolts and shift lever.