Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE) > DISASSEMBLY

for Preparation Click here



1. REMOVE COOLER BRACKET


E173473
  1. Disconnect the connector.

  1. Detach the clamp.

  1. Remove the screw and cooler bracket.



2. REMOVE MAGNET CLUTCH ASSEMBLY


E156529E01
  1. Clamp the cooler compressor in a vise between aluminum plates.

  1. Using SST, hold the magnet clutch hub.

    SST
    07112-76060  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.



    I104018
  1. Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Detach the clamp.



    I104019
  1. Using a snap ring expander, remove the snap ring and magnet clutch stator.