RADIATOR > ON-VEHICLE INSPECTION |
| 1. CHECK RADIATOR RESERVOIR CAP SUB-ASSEMBLY |
![]() |
Measure the valve opening pressure.
If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.
Check that O-ring 1 is not deformed, cracked or swollen.
Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.
![]() |
When using the cap tester, tilt it upwards 30° or more.
Pump the cap tester several times, and check the maximum pressure*.
| Item | Specified Condition |
| Standard value (for brand-new cap) | 93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi) |
| Minimum standard value (for used cap) | 78.5 kPa (0.8 kgf/cm2, 11.4 psi) |