Home › ENGINE ยท 2GR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A195884E01
  1. Apply a light coat of gasoline to 2 new O-rings and install them onto the fuel pressure regulator.



    A197089
  1. Install the fuel pressure regulator to the fuel filter.



2. INSTALL FUEL PUMP ASSEMBLY


    A195890
  1. Connect the fuel pump connector.



    A197087E02
  1. Install the fuel pump spacer to the fuel pump assembly.

  1. Apply gasoline to a new O-ring and install the O-ring to the fuel pump.



    A197085
  1. Attach the 5 claws to the holes to install the fuel pump.



3. INSTALL NO. 1 FUEL SUCTION SUPPORT


    A126126
  1. Attach the 2 claws to the holes to install the No. 1 fuel suction support.



4. INSTALL NO. 1 FUEL SUB-TANK


    A126125
  1. Attach the 2 claws to the holes and install the No. 1 fuel sub-tank.



    A126123
  1. Connect the wire harness.



    A126684
  1. Install the 2 springs to the fuel suction plate shafts, and then install them to the No. 1 fuel sub-tank.



    A201342E01
  1. Using needle-nose pliers, install a new E-ring.

    HINT:
    Slightly lower the fuel suction plate to install the E-ring.



5. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY


    A126699E02
  1. Install a new gasket onto the fuel suction with pump.



    A202412E01
  1. Connect the fuel hose with the paint mark facing towards the top of the vehicle, and then secure the clip.

  1. Install the fuel suction with pump into the fuel tank.

    NOTICE:
    Do not damage the fuel suction with pump.



6. INSTALL FUEL TANK VENT TUBE SET PLATE


    A124675
  1. Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



7. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A124668
  1. Install the fuel tube with the joint clip.

    NOTICE:
    A124131E05
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the fuel tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
    5. Be careful not to damage the clip. If the clip is damaged, replace it.



8. CONNECT FUEL EMISSION HOSE


    A203591E01
  1. Connect the purge line hose, air inlet line hose to the fuel suction plate.

  1. Connect the fuel emission hose to the fuel suction plate.

    HINT:
    Firmly push the tube connector until a "click" sound is heard.

    NOTICE:
    1. Before connecting the hose, check if there is any damage or foreign matter in the hose or connector.
    2. Check that the connector is connected by pulling on it.



9. INSTALL FUEL TANK ASSEMBLY
  1. Install the fuel tank assembly (Click here).