Home › ENGINE · 1AZ-FE › FUEL › FUEL PUMP

FUEL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP ASSEMBLY


A197970E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    0.2 to 3.0 Ω

    If the result is not as specified, replace the fuel pump assembly.



  1. Inspect the operation of the fuel pump.



      A197971E01
    1. Connect the positive (+) lead of the battery to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.
      If the pump does not operate, replace the fuel pump assembly.

      NOTICE:
      1. This test must be performed within 10 seconds to prevent the coil from burning out.
      1. Keep the fuel pump as far away from the battery as possible.
      1. Always turn the voltage on and off on the battery side, not the fuel pump side.