Home › ENGINE ยท 2AZ-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. REMOVE FUEL TANK ASSEMBLY
  1. Remove the fuel tank assembly (Click here).



2. DISCONNECT FUEL EMISSION HOSE


    A202413E01
  1. Disconnect the purge line hose, air inlet line hose and fuel emission hose from the fuel suction plate.

  1. Pinch the retainer as shown in the illustration, and then disconnect the fuel emission hose from the fuel suction plate.

    NOTICE:
    1. Clean off any dirt and foreign matter from the clip before disconnecting the hoses.
    2. Do not use any tools in this procedure.
    3. Do not forcefully bend or twist the nylon tube.
    4. Put the hose in a plastic bag to prevent damage and contamination.
    5. If the connector is stuck, pinch the retainer and push and pull the hose to disconnect it.



3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A124669
  1. Remove the joint clip and fuel tank main tube.

    NOTICE:
    1. Before removing the tube joint clip, check for foreign matter around the clip. Clean if necessary.
    2. Keep the O-ring free of foreign matter, as it becomes contaminated easily.
    3. Do not use any tools in this procedure.
    4. Do not forcefully bend or twist the tube.
    5. Put the tube in a plastic bag to prevent damage and contamination.
    6. If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
    7. Be careful not to damage the clip. If the clip is damaged, replace it.



4. REMOVE FUEL TANK VENT TUBE SET PLATE


    A124675
  1. Remove the 8 bolts and set plate.



5. REMOVE FUEL SUCTION WITH PUMP ASSEMBLY


    A124676
  1. Disconnect the fuel hose and remove the fuel suction with pump from the fuel tank.

    NOTICE:
    Do not damage the fuel suction with pump.



    A126699E02
  1. Remove the gasket from the fuel suction with pump.



6. REMOVE NO. 1 FUEL SUB-TANK


    A126123
  1. Disconnect the wire harness.



    A201342E01
  1. Using needle nose pliers, remove the E-ring.

    HINT:
    Slightly lower the fuel suction plate to remove the E-ring.



    A126684
  1. Remove the 2 springs from the 2 shafts.



    A126125
  1. Detach the 2 claws and remove the No. 1 fuel sub-tank.



7. REMOVE NO. 1 FUEL SUCTION SUPPORT


    A126126
  1. Using needle-nose pliers, detach the 2 claws and remove the No. 1 fuel suction support.



8. REMOVE FUEL PUMP ASSEMBLY


    A197085
  1. Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.

    HINT:
    When detaching the claws, do not disconnect the fuel main tube.



    A197086
  1. Disconnect the fuel pump connector.



    A197087E01
  1. Remove the O-ring from the fuel filter.

  1. Remove the fuel pump spacer from the fuel pump assembly.



9. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A197088
  1. Remove the pressure regulator from the fuel filter.

  1. Remove the 2 O-rings.