FUEL PRESSURE REGULATOR > REMOVAL |
| 1. REMOVE FUEL TANK ASSEMBLY |
Remove the fuel tank assembly (Click here).
| 2. DISCONNECT FUEL EMISSION HOSE |
![]() |
Disconnect the purge line hose, air inlet line hose and fuel emission hose from the fuel suction plate.
Pinch the retainer as shown in the illustration, and then disconnect the fuel emission hose from the fuel suction plate.
| 3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Remove the joint clip and fuel tank main tube.
| 4. REMOVE FUEL TANK VENT TUBE SET PLATE |
![]() |
Remove the 8 bolts and set plate.
| 5. REMOVE FUEL SUCTION WITH PUMP ASSEMBLY |
![]() |
Disconnect the fuel hose and remove the fuel suction with pump from the fuel tank.
![]() |
Remove the gasket from the fuel suction with pump.
| 6. REMOVE NO. 1 FUEL SUB-TANK |
![]() |
Disconnect the wire harness.
![]() |
Using needle nose pliers, remove the E-ring.
![]() |
Remove the 2 springs from the 2 shafts.
![]() |
Detach the 2 claws and remove the No. 1 fuel sub-tank.
| 7. REMOVE NO. 1 FUEL SUCTION SUPPORT |
![]() |
Using needle-nose pliers, detach the 2 claws and remove the No. 1 fuel suction support.
| 8. REMOVE FUEL PUMP ASSEMBLY |
![]() |
Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.
![]() |
Disconnect the fuel pump connector.
![]() |
Remove the O-ring from the fuel filter.
Remove the fuel pump spacer from the fuel pump assembly.
| 9. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Remove the pressure regulator from the fuel filter.
Remove the 2 O-rings.