Home › ENGINE ยท 1AZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here


HINT:
The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (Click here).



1. CHECK CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    B127990E01
  1. Check the operation.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester main switch ON.

    4. Start and warm up the engine.

    5. Select the menu items: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1).

    6. Operate the OCV using the intelligent tester, and then check the engine speed.

      Standard condition:
      Tester Operation
      Specified Condition
      OCV is OFF
      Normal engine speed
      OCV is ON
      Rough idling or engine stalls

      If the operation is not as specified, check the oil control valve, wire harness and ECM.