Home › ENGINE · 1AZ-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


  1. Measure the resistance of the sensor.


    A108624E06

    Standard resistance:
    Tester Connection
    Specified Condition
    1 (E2) - 2 (THW)
    2.32 to 2.59 kΩ at 20°C (68°F)
    1 (E2) - 2 (THW)
    0.310 to 0.326 kΩ at 80°C (176°F)

    NOTICE:
    If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off of the sensor.

    If the result is not as specified, replace the sensor.