Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.



2. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the 2 cylinder block drain cock plugs.


    A126964E01



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A137022E02
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor and gasket.

    SST
    09817-33190