Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR


    A129616E02
  1. Install the 2 sensors with the 2 bolts as shown in the illustration.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }

    NOTICE:
    Make sure that the knock sensor is in the correct position.

  1. Connect the 2 sensor connectors.



2. INSTALL INTAKE MANIFOLD


    A076536E01
  1. Set a new gasket on each cylinder head.

    NOTICE:
    1. Align the port holes of the gasket and cylinder head.
    2. Be careful of the installation direction.

  1. Set the intake manifold on the cylinder heads.



    A076533E01
  1. Install and uniformly tighten the 6 bolts and 4 nuts in several passes.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the 6 fuel injector connectors.



3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
  1. Install the intake air surge tank assembly (Click here).



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. INSPECT FOR FUEL LEAK
(Click here)


6. INSPECT FOR OIL LEAK
  1. Start the engine. Make sure that no oil leaks from the connections of the oil filter cap.