Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
  1. Remove the intake air surge tank assembly (Click here).



3. REMOVE INTAKE MANIFOLD


    A076533E01
  1. Remove the 6 bolts, 4 nuts, intake manifold and 2 gaskets.



4. REMOVE KNOCK SENSOR


    A129615
  1. Disconnect the 2 sensor connectors.

  1. Remove the 2 bolts and 2 sensors.