Home › ENGINE ยท 2AZ-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE ACCELERATOR PEDAL ROD


    A127589E01
  1. Disconnect the accelerator pedal position sensor connector.

  1. Remove the 2 bolts and accelerator pedal rod.