Home › ENGINE ยท 1AZ-FE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE AIR CLEANER CAP


    A124559
  1. Disconnect the mass air flow meter connector.

  1. Disconnect the purge VSV connector.

  1. Disconnect the 4 wire harness clamps.



    A124560
  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Disconnect the purge line hose from the clamp.



    A124561
  1. Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.



    A124562
  1. Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.



3. REMOVE AIR CLEANER CASE


    A124563
  1. Disconnect the harness clamp.

  1. Remove the 3 bolts and air cleaner case.



4. REMOVE ECM


    A124570
  1. Remove the 3 bolts from the ECM with brackets.



    A124571E01
  1. Disconnect the 2 ECM connectors.

    NOTICE:
    After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.


    1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.

  1. Remove the ECM with brackets.



    A124573
  1. Remove the 4 screws and 2 ECM brackets.