Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A173728
  1. Disconnect the mass air flow meter connector.

  1. Disconnect the VSV (air intake control) connector.

  1. Disconnect the 2 wire harness clamps and 2 vacuum hoses.

  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Loosen the No. 1 air cleaner hose clamp.

  1. Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.



3. REMOVE AIR CLEANER CASE
  1. Disconnect the harness clamp.



    A137898
  1. Remove the 3 bolts and air cleaner case.



4. REMOVE ECM


    A124570
  1. Remove the 3 bolts of the ECM bracket.



    A124571E01
  1. Disconnect the 2 ECM connectors.

    NOTICE:
    After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.


    1. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

  1. Remove the ECM with bracket.



    A124573
  1. Remove the 4 screws and 2 ECM brackets.