Home › ENGINE ยท 2AZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR


A095434E01

NOTICE:
Make sure that the O-ring is not cracked or jammed when installing it.

  1. Apply a light coat of engine oil to the O-ring of the sensor.



    A124557
  1. Install the sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

  1. Connect the sensor connector.



2. INSTALL AIR CLEANER CAP
  1. Install the air cleaner filter element onto the air cleaner case.



    A124568E01
  1. Insert the hinge part of the air cleaner cap into the air cleaner case, then hang the 2 hook clamps.



    A124569E01
  1. Align the matchmarks of the No. 1 air cleaner hose and throttle body, and then connect the air cleaner hose No. 1 to the throttle body and unfasten the No. 1 air cleaner hose clamp.

    NOTICE:
    Make sure that the hose clamp is at the correct angle.



    A124560
  1. Connect the purge line hose to the clamp.

  1. Connect the No. 2 ventilation hose to the air cleaner hose.



    A124559
  1. Connect the 4 wire harness clamps.

  1. Connect the mass air flow meter connector.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. CHECK FOR ENGINE OIL LEAKAGE


5. INSTALL NO. 1 ENGINE COVER
  1. Install the air cleaner filter element onto the air cleaner case.



    A124568E01
  1. Insert the hinge part of the air cleaner cap into the air cleaner case, then hang the 2 hook clamps.



    A124569E01
  1. Align the matchmarks of the No. 1 air cleaner hose and throttle body, and then connect the air cleaner hose No. 1 to the throttle body and unfasten the No. 1 air cleaner hose clamp.

    NOTICE:
    Make sure that the hose clamp is at the correct angle.



    A124560
  1. Connect the purge line hose to the clamp.

  1. Connect the No. 2 ventilation hose to the air cleaner hose.



    A124559
  1. Connect the 4 wire harness clamps.

  1. Connect the mass air flow meter connector.